banner

    CONTACT US

  • contact us
  • TEL:86-13902617335
  • Contact:Lisa Lu
  • Mail:kyd@kuaiyuda.com
  • Address:No.6 Keyuan 8th Road,Keyuan Industrial Park,Tianxin Village,Tangxia Town,Dongguan City,Guangdong Province
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine

Medical Slip Pad Making Machine

  • Date:2023-11-07
  • Visits:1115
Medical sliding pad machine: This machine is an equipment for fully automatic production of medical sliding pads, from fabric feeding, edge welding, perforation, finished product cutting and automatic output; the entire production process is fully automated. The whole device only needs one person to operate, the built-in PLC program controls the operation, the control is accurate and stable, and the medical sliding pad of different specifications can be produced by adjusting the parameters.
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Medical Slip Pad Making Machine
  • Product introduction
  • Related products
  • Product Name

    Medical Slip Pad Making Machine

    Detection mode

    Photoelectric detection

    Size

    5500*1500*1700mm

    Voltage

    220V

    Power

    5KW

    Pressure

    6kg/cm2

    Yield

    5-7pcs/min

    Control Mode

    PLC

    image.png

    image.png

    image.png

    image.png

    image.png

    The power supply of the machine is AC AC220V, the total power is 5.5KW, the maximum working current is 36A, the diameter of the power socket line shall not be less than 3.4 square copper core line, the machine must be reliably grounded, the machine should be first ventilated and then energized, the working environment temperature of all sensors should be above 0 degrees, and the air pressure should be maintained at 6-8kg.

    Safety check: check to make sure there is no debris on the worktable and no other person is operating the machine. After safety inspection and normal power supply, the machine should perform the following operations.

     

    5. 1. The start

    Click: press the click button, the machine will run at the original speed during pressing, when release the button, the machine will stop immediately.

    Linkage: click the start button, the machine will continue to move at the set speed until the stop (red) or emergency stop (mushroom head) button is pressed.

    5. 2. Stop

    1. Normal shutdown

    Press the stop (red) button and the machine will stop running.

    2. Emergency shutdown

    When the machine stops or operates abnormally, the machine stops immediately. After restarting, the cylinder, motor and switch can be operated again after the origin is restored. If the origin cannot be restored again, the elimination method is to turn OFF the power supply and remove the pressure source gas. After manual adjustment, connect the air pressure source and send power again to start the normal operation.